Cutting Panels

Ensure the panel is well supported either on a table or other panels. Use of a clean blanket or similar will reduce the chances of scratching. Make sure to shake off any machine swarfe or vacuum clean between operations.

Before cutting EnduraPanel, double check all sizes and geometry. Measure the width, height and triangular distance across opposing corners to determine the size and squareness of the panel required.

Using a suitable marker e.g. ballpoint pen, pencil etc mark out the sizes.

Always use sharp blades suitable for cutting EnduraPanel (see Circular Saw).

Generally speaking, panels can be cut using most commonly accepted practices used for machining MDF.

 

download Download the EnduraPanel Machining brochure