Removing Protective Film

EnduraPanel is supplied with protective film on both sides:

The COATED SIDE has a plastic film design for protection of the coated surface. Remove this film when all machining operations are complete and the panel is ready to be adhered to the wall/surface.

The EXPOSED SIDE has a clear plastic film designed for protection against scratches. Peel back 25mm from the edge before inserting into a joining system. Completely remove the film only at the last stage by gently peeling down the sheet surface – never at right angles to the sheet as this may pull the sheet away from the installed wall/surface (see specialist section).

Never attempt to cut the protective films with a knife as this may scratch the surface.