Permanent Fixing to Dry Areas

INSTRUCTIONS 

  • Apply full-length beads around the perimeter of EnduraPanel staying approximately 25mm from the edge to allow for insertion into EnduraPanel joiners
  • Apply full-length beads at 200mm centres in a stripe pattern
  • If installing into EnduraPanel jointing systems, insert into extrusion first
  • Roll EnduraPanel onto the wall starting with one edge and smoothing the panel out in the direction of installation
  • There is no need to apply excessive pressure – a firm hand is enough to spread out adhesive 
  • Clean up any adhesive that spills out the sides of the EnduraPanel NOTES
  • If installing EnduraPanel into wet areas, refer to special instructions on shower installations 
  • If installing EnduraPanel using silicon joints, always use glazing industry silicon jointing standard practices
  • Methods may vary between different adhesive products, always follow manufacturer’s instructions

 

permfixtodryarea.gif